Assembly And Installation - Samoa MP30 Parts And Technical Service Manual

EN
DESCRIPTION
Preset mechanical meters, with volumetric rotatory piston. MP30 have been
specifically designed to measure and dispense volumes of all kinds of synthetic
and mineral oils.
Graduated in "liters", "quarts/gallons" or "gallons", it is suitable to fill engines,
gear boxes and transmissions; or dispense lubricants in fleet service shops, off-
road vehicles, mining or marine equipment maintenance facilities.
!
CAUTION
Always read and follow the fluid manufacturer's recommendations
regarding the use of protective eye wear, clothing, gloves, and other
personal protective equipment.
Do not alter or modify any parts of this product; doing so may cause
damage and/or personal injury.
IMPORTANT
Read these safety warnings and instructions in this manual completely,
before installation and start up of the meter.
It is the responsibility of the purchaser to retain this manual
for reference.
Failure to comply with the recommendations stated in this manual
will damage the meter and void factory warranty.

ASSEMBLY AND INSTALLATION

To use the preset mechanical meter only it's necessary put the nozzle and
connect the control valve to the fluid hose.
Nozzle assembly (1)
To ensure sealing, screw the nozzle using the provided o-ring or bonded seal
in correct place.
Control valve connection to the fluid hose (2)
Attach the swivel cover to the hose before installing the oil gun in the system.
The swivel cover is compatible with 1/2" hoses, either with male fixed
terminal or swivel nut (Fig. 1). Deppending on the terminal type hose may
be necessary open the end of the swivel cover to place through the hose. The
swivel cover includes a slot in it for easy opening (Fig. 2)
To connect the gun to piping system, fix the gun body. Rotate the free end
of the swivel until desired torque (Fig. 3).
1
Fig.
2
836 867 R. 06/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. 2
The line of preset mechanical meter is especially designed to support a severed
use and extreme environmental conditions. A robust integral polycarbonate
based housing guarantees maximum strength against drops and impacts. No
calibration required, high-accuracy to a large viscosity range.
!
DANGER
Not for use with fluids that have a flash point below 38 ºC (100 ºF),
for example: gasoline or alcohol. Sparking could result in an explosion
which could result in death.
Use the equipment with fluids which are compatible with the wetted
parts of the equipment. See the relevant section of technical
specifications.
Do not exceed the maximum working pressure or temperature. See
the relevant section of technical specifications.
Release all pressure in the system before performing any installation
or maintenance on the equipment.
Do not place your hand or fingers over the dispensing nozzle and/or
aim the nozzle at a person at any time. Personal injury may result.
Airborne particles and loud noise hazards.
Use ear and eye protection.
Fig. 3