Table of Contents
Advertisement
1.2 Warnings and Safety Notes
Transport
The LCD-monitor should only be transported in its original packaging to ensure it will be protected
against shocks and rough handling.
Setting up
When installing the monitor, it should be noted whether any moisture (condensation) has entered the
unit during transport or storage. Additional important installation information can be found in the
"Technical Data" chapter.
EMC
This is a Class A piece of equipment (industrial use). In domestic situations, it may cause
interference. Under such circumstances, the operator can be required to undertake appropriate
measures to minimise problems
.
This LCD-monitor is a component designed for building into industrial systems. The operator of the
entire plant is responsible for maintaining electromagnetic compatibility according to EMC-law.
Repairs
Before the unit is opened, the supply voltage must be switched off. Only authorised persons may
open the unit.
Additions or changes to the unit may damage the system or affect its EMC behaviour.
Cleaning
The unit must be isolated from the power supply before cleaning. If heavily soiled, the LCD-monitor
can be cleaned with a damp cloth and mild detergent. Care must be taken to ensure that no moisture
enters the unit during cleaning.
Scouring powders and solvents must never be allowed to come in contact with the unit. The inside of
the unit is to be cleaned by qualified service technicians only.
LCD-Monitor SCD1297
Page 6 / 19
DOC-No.: B3 0071D1.DOC
Advertisement
Table of Contents
