Settings For Virtual Sensors - wtw IQ SENSOR NET NiCaVis 705 IQ NI Operating Manual

Commissioning
Carrying out settings
Menu item
Measuring mode
(NitraVis 70x IQ NI)
Measuring mode
(CarboVis 70x IQ NI)
Measuring location
Measuring range
Cal - # raw value 1
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
3 - 12

3.4.4 Settings for virtual sensors

Using <S>, switch from the measured value display to the main menu
of the settings. Then navigate to the setting menu (setting table) of the
sensor. The procedure is described in detail in your IQ S
system operating manual.
Default values are marked in bold.
Settings
NO3-N

NO3

NO2-N

NO2

COD spectr., total

COD spectr., dissolv

TOC spectr., correl.

BOD spectr., correl.

DOC spectr., correl.

SAC 254, total

SAC 254, dissolved

UVT 254

NiCaVis 701 IQ NI
Activation

Inlet

Outlet

NiCaVis 705 IQ NI
Outlet

(permanently set)
-
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Explanations
The measured parameter is displayed
in the selected citation form.
The measured parameter is displayed
in the selected citation form.
:
Measurement location or application of
the sensor.
 The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
:
 The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
Display of the measuring range
(see chapter 8 T
NiCaVis 70x IQ NI
N
ENSOR ET
).
ECHNICAL DATA
ba75988e01 11/2012