Table of Contents
Advertisement
NiCaVis 70x IQ NI
Measuring location
User calibration after initial
commissioning
ba75988e01
11/2012
3.4
Initial commissioning
3.4.1 General information
CAUTION
Never look into the measuring window or put objects into the measur-
ing window during operation! The emitted UV radiation can damage the
eyes!
In the case of authorized use, inadvertent eye contact with the light
beam is not possible.
The sensor is immediately ready to measure.
How to adjust the settings is described in the following section (section
3.4.3).
On the basis of a reference measurement ("laboratory value"), check
whether the default settings deliver sufficiently accurate measured
values or whether you want to carry out a user calibration (see section
4.3 C
).
ALIBRATION
Commissioning
3 - 7
Advertisement
Table of Contents
