Crosley XCF200 Owner's Manual page 19

Cleaning the Range – Exterior (Cont.)
Surface Units
WARNING
■ Be sure the controls are turned to OFF and the surface
units are cool before attempting to remove them .
■ Do not immerse the surface units in liquids of any kind .
■ Do not clean the surface units in a dishwasher .
■ Do not bend the surface unit plug terminals .
■ Do not attempt to clean, adjust or in any way repair
the plug-in receptacle .
■ Do not pull on the SENSI-TEMP TECHNOLOGY
sensor cap .
To clean the surface units, turn the control to the highest
setting for a minute . The coils will burn off any soil . To
clean the Sensi-Temp Technology Sensor cap, wipe
with a damp sponge or cloth . For cooked-on food spills,
remove the burner from the range and gently scrub the
cap and supports with a damp plastic scouring pad . Do
not use steel wool . Allow the burner to dry over night
before re-installing it .
To remove a surface unit:
To remove the drip pans for cleaning, the surface units
must be removed first .
1 . Push the surface unit back toward the receptacle .
2 . Lift the surface unit about 1 inch above the drip pan
and pull it out .
Do not lift the surface unit more than 1 inch . If you do, it
may not lie flat on the drip pan when you plug it back in .
NOTE: Repeated lifting of the surface unit more than
1 inch above the drip pan can permanently damage the
receptacle .
To replace a surface unit:
1 . Replace the drip pan into the recess in the cooktop .
Make sure the opening in the pan lines up with the
receptacle .
2 . Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle .
3 . Push the surface unit in and down so it rests evenly in
the cooktop .
49-2001211 Rev. 1
Cooktop Rim
When properly seated, the locking tab should lock onto
the cooktop rim through the notch in the drip pan .
Surface Unit
Receptacle
Surface Unit
Drip Pan
Locking Tab
Locking
Tab
Drip Pan
Locking Tab
19