Option A: Speakers With Ncs - BRP VIBE User Manual

B. VIBE COMMUNICATION SYSTEM
INSTALLING THE ANTENNA
7. Slide the antenna into the hole on the
right.
8. Pass the wire into the slot and hole.
9. Place the cable so it does not
interfere with the magnet
10. Re-install the accessories cover.

4.1. OPTION A: SPEAKERS WITH NCS

A.1. Remove the NCS (Noise Control
System) from the helmet (held by
Velcro . ).
A.2. Remove the foam cut out from
each NCS by ripping the center circle
portion.
A.3. Remove the white foam inside the
NCS.
A.4. Disconnect the speaker from the
main module by pulling on both ends of
the connector.
A.5. Pass the speaker connection into
the hole in the back of the NCS so that it
points to the back of the helmet.
7