Vibe Installation - BRP VIBE User Manual

B. VIBE COMMUNICATION SYSTEM
REMOVING THE REAR TRIM
5. Using either marking on the rear trim,
push the trim away from the helmet by
pressing directly on the trim.
REMOVING THE ACCESSORY COVERS
6. Remove the accessory covers by
pulling it away from the helmet. Do this
on both sides of the helmet. The
accessory covers are held magnetically.
REMOVING THE EPS
7. Remove the EPS piece (foam)
located under the trim.

3. VIBE INSTALLATION

INSTALLING THE MAIN UNIT
1. Place the "Main Unit" in the slot left by
the EPS from previous step.
2. If helmet is equipped with eLinQ
option, remove the end cap on the RED
connector.
3. Connect the left connector with the
RED female connector on the helmet.
4. Make sure the RED connector is
plugged the right way with the arrow
pointing to the Sena logo.
INSTALLING USER INTERFACE
4. Pass the wire sideways into the slot
and hole on the left.
5. Slide the antenna into the hole and
magnetically clip the user interface.
6. Make sure the user interface tab next
to the wire is locked into the rectangular
hole.
6