Husqvarna TrioBrake 550XPG Workshop Manual page 48

Repair Instructions
Fitting on the saw
1
Press the connector together as outlined in figure
46 and push it into place in the holder.
2
Make sure the cabling is fitted to its mounting on
the intake flange.
Press the fuel hose in place in the collar on the
intake bellows.
Hook on the throttle cable E in its mounting on the
intake bellows. See figure 48.
Make sure the lug on the carburettor hooks in
place on its mounting on the intake system.
Make sure that the following components are
correctly fitted:
• Position the air filter holder against the carburettor.
• Make sure the carburettor cover's intake channel
is aligned correctly with the slot for the air filter
holder.
• The spring must be fitted under the choke pin on
the carburettor. See figure 49.
• The rubber collar on the stop button must be on
the inside of the bottom of the carburettor com-
partment. See figure 49.
NOTE!
Make sure that the fuel and return hoses
are not crushed.
48
- English
Fig 46
Fig 47
C
Fig 48
D