Imetec ONDA F1 User Instructions page 18

WARNING! This appliance is not to be used if it has been
EN
dropped, if there are visible signs of damage or if it is leaking
water.
Use only demineralised water for irons.
WARNING! DO NOT pour diluting agents, scented liquids or
descaling agents into the reservoir as the use of these
substances can damage the product.
WARNING! Do not use water from dryers, air-conditioners or
tumble dryers, filtered water with water softeners, or
rainwater.
The reservoir may contain some water as each product is tested before being put on the market.
Check that the power supply cable with plug (2) is plugged into the socket.
Move the steam selector (10) to the steam closed position [Fig. C].
Open the water fill cover (9).
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly fill the water in the reservoir (6) using the water cup (13) [Fig. B].
Do not exceed the maximum fill level shown on the reservoir (6).
Close the water fill cover (9).
SELECTING THE TEMPERATURE
Set the iron upright.
Plug the power supply cable with plug (2) into the socket.
Set the temperature according to the type of fabric in line with the international symbols shown on the
labels; using the adjustment knob (2) [Fig. D].
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to go off before starting to iron.
It is recommended that you place a cloth between the iron and the fabric when using the iron
for the first time.
Before starting ironing, direct a jet of steam onto the cloth by lifting the iron slightly so that any
residual condensation comes out.
Fabrics with the following symbols may not be ironed:
15
USE