Table of Contents
Advertisement
• Configure Solar Combination options: Disabled, Input Demand, Total Control. (only in case DHW
is enabled).
• Enable or disable Hydraulic separator status.
• Select Next and press OK button.
• Configure circuit 1 and circuit 2 options: Disabled, Points, Gradient, Fix.
• Only available for cooling mode.
• Enable or disable Cascade Mode.
• Configure Central mode options: Full, water, air or local. Only available when Cascade Mode is
disabled.
• Configure thermostat 1 or 2 (depending on previous settings): None, wired or wireless.
• Check RT address if wired is selected.
• Select Wireless binding ID (1 or 2) if wireless is selected.
• Select Wizard complete and press OK button.
• Select Yes to complete the advance configuration.
• Press OK button to go to the main screen.
PMEN0602 rev.0 - 05/2023
1
22
Advertisement
Table of Contents
