Disassembly Procedure - Mitsubishi Electric SLZ Series Technical & Service Manual

11

DISASSEMBLY PROCEDURE

SLZ-KF09NA1 SLZ-KF12NA1 SLZ-KF15NA1 SLZ-KF18NA1
OPERATING PROCEDURE
1. Removing the air intake grille and air filter
(1) Slide the knob of air intake grille to the direction of the
arrow 1 to open the air intake grille.
(2) Remove the grille hook from the panel to prevent the
grille from dropping.
(3) Slide the hinge of the intake grille to the direction of the
arrow 2 and remove the air filter.
2. Removing the panel
(1) Remove the air intake grille. (Refer to procedure 1)
Connector box (See Photo 1)
(2) Remove the screw of the connector cover.
(3) Slide the connector cover to the direction of the arrow to
open the cover.
(4) Disconnect all the connectors, then pull out the
connectors that are coming from panel side from the
connector box.
Corner panel (See Figure 2 and Photo 2)
(5) Loosen the screw from the corner of the corner panel.
(6) Slide the corner panel as indicated by the arrow.
(7) Remove the safety strap from the hook, then remove the
corner panel from the panel.
(The safety strap is not equipped for the signal receiver
panel and i-see Sensor corner panel.)
(8) Remove the fastener (*), then remove the corner panel.
Panel (See Photo 3)
(9) Remove the 4 screws.
(10) Unlatch the 2 hooks.
* Fastener is only for the signal receiver and i-see Sensor corner panel.
TCH118
PHOTOS/FIGURES
Figure 1
Air intake grille
1
1
Air intake grille knobs
Photo 1
Connector box
Fastener*
Figure 2
Screw
Corner panel
Photo 2
Safety strap
Photo 3
Hook
29
Be careful when removing heavy parts.
Grille hook
2
Grille
Screw
Connector cover Connector cover
Grille
Hook Hook
Screws
Turbo fan Turbo fan
Screws Screws Screws Screws
Air fi lter
Fastener*
Nut and
washer washer washer
Hook