Disassembly Procedure - Mitsubishi Electric Mr.Slim PLA-A12BA6 Service Manual

DISASSEMBLY PROCEDURE

11
PLA-A12BA6
PLA-A30BA6
OPERATING PROCEDURE
1. Removing the air intake grille
(1) Slide the knob of air intake grille toward the arrow 1 to
open the air intake grille.
(2) Remove drop prevention hook from the panel.
(3) Slide the shaft in the hinge to the direction of the arrow 2
and remove the air intake grille.
2. Removing the room temperature thermistor (TH1)
(1) Remove the air intake grille and the filter. (See Figure 1)
(2) Remove the 2 screws from the electrical box.
(3) Disconnect the connector CN20 (Red) from the indoor con-
troller board.
(4) Remove the room temperature thermistor and holder.
3. Removing the indoor controller board (I.B)
(1) Remove the air intake grille and the filter. (See Figure 1)
(2) Remove the 2 screws from the electrical box cover.
(3) Disconnect the connectors :
CNMF (White/ 7P) for fan motor
CN44 (White/ 4P) for thermistor (TH2/ TH5)
CNP (Blue/ 3P) for drain pump
CN4F (White/ 4P) for float switch
CN01 (Black/ 5P) for earth and reactor
CNV (White/ 20P) for vane motor
(4) Remove the 6 supports from indoor controller board.
(5) Remove the indoor controller board.
4. Removing the electrical box
(1) Remove the air intake grille and the filter. (See Figure 1)
(2) Remove the 2 screws from the electrical box cover.
(3) Disconnect the connectors. (Refer to step 3)
(4) Remove 2 electrical box fixing screws and remove 2 hooks.
(5) Pull the electrical box.
<Electrical parts in the electrical box>
Indoor controller board
Terminal block (TB4)(TB5)
OCH581
PLA-A18BA6
PLA-A36BA6
PLA-A24BA6
PLA-A42BA6
PHOTOS & ILLUSTRATIONS
Figure 1
Photo 1
Electrical box cover
Photo 2
Electrical box
fixing screw
Electrical box
35
Be careful when removing heavy parts.
Filter
Fixing screw
(Electrical box)
Room temp.
Bell mouth thermistor (TH1)
Turbo fan
Electrical box
Indoor controller
fixing screw
board (I.B)