Table of Contents
Advertisement
00078A DVD-V72K/XSA-GB2
6/25/02 11:43 AM
Page 36
VCR
Searching for a Specific Sequence
GB
INDEX
:
INTRO SCAN :
INDEX SEARCH :
- 6
36
Each time you record a cassette on this VCR, an "index" is
automatically marked on the tape when recording starts.
The Search function allows you to fast-forward or rewind to a
specific index and start playback from that point. Depending on the
direction selected, the indexes are numbered as follows:
Prev
Seq. being
Next
played
Seq.
etc.
Seq.
etc.
2
1
1
2
This VCR uses a standard indexing system (VISS). As a
result, it will recognize any indexes marked by other
VCRs using the same system and vice versa.
INTRO SCAN
1
To search for a specific index, press INDEX.
2
Press the
or
buttons depending on the direction
where your desired programme is located.
3
When an Index mark is found the VCR will playback the tape for 5
seconds, after which it will continue searching for the next Index
mark.
4
If you want to watch the tape from a particular Index, simply press
Index Skip Search:
This feature will enable you to fast forward/rewind to a specific
point on a tape: E.g. if you have recorded 3 different programmes
on a tape and you have rewound the tape to the beginning, by
using this feature you can go directly to the start of programme 2
simply by pressing the INDEX button.
1
Press the INDEX to start the Index search.
2
Press the
or
buttons twice more. This will take
you directly to the start of the desired programme is located.
3
These Index searches can be made forwards: (press
backwards: (press
).
4
To cancel an Index search simply press the
or
II
You can set an index number up to ±20.
Using the Tape Counter
The tape counter:
Indicates the elapsed time in the play and record modes
(hours, minutes and seconds)
Is reset when a cassette is inserted in the DVD-VCR
Allows you to find the beginning of a sequence easily
If the remaining time is to be calculated correctly, you
must indicate the type of cassette being used.
1
Insert a cassette in your DVD-VCR.
2
To set the tape counter to zero at the beginning of a sequence:
Press DISPLAY twice to display the counter
Press CLEARwhen you want to set the tape counter to zero
3
To fast-forward or rewind to the sequence at which the counter
was set to zero, simply press
Result:
The DVD-VCR stops automatically when the counter
reaches zero.
Some DVD-VCR information, such as the counter, can be
displayed on the television screen (unless you have
deactivated the OSD mode; refer to page 26).
Press DISPLAY:
Once to display the current function, programme
.
II
number, recording speed, date, time and counter
Twice to display the counter only
Three times to display the time remaining on the
cassette
Four times to clear the display
) or
button.
or
.
VCR
GB
0 : 0 0 : 0 0
2
2
37
Advertisement
Table of Contents
