Beko QWM84 User Manual page 34

Maintenance and cleaning
a. Pull the emergency draining hose out from
its seat
b. Place a large container at the end of the
hose. Drain the water into the container by
pulling out the plug at the end of the hose.
When the container is full, block the inlet
of the hose by replacing the plug. After
the container is emptied, repeat the above
procedure to drain the water in the machine
completely.
c. When draining of water is finished, close the
end by the plug again and fix the hose in its
place.
d. Turn the pump filter to take it out.
Discharging the water when the product does
not have an emergency draining hose:
a. Place a large container in front of the filter to
catch water from the filter.
b. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing water
into the container you have placed in front of
the filter. Always keep a piece of cloth handy
to absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely by
turning it.
4. Clean any residues inside the filter as well
as fibers, if any, around the pump impeller
region.
5. Install the filter.
6. If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab.
If it is one piece, seat the tabs in the lower
part into their places first, and then press
the upper part to close.
34 / EN
Washing Machine /User's Manual