Table of Contents
Advertisement
Troubleshooting
Problem
Laundry remains
wet at the end of
the programme.
(*)
Washer fills with
water when
a process is
cancelled.
Time delay
function does
not work.
The door will not
lock/door led
remains OFF.
Clothes get
tangled up too
much in the
drum when
washing.
Load is wrinkled.
Owner's Guide & Installation Instructions
Reason
Excessive foam might have
occurred and automatic foam
absorption system might have
been activated due to too
much detergent.
Unbalance detection due to
small amount of laundry inside
the drum and/or uneven load
distribution.
Poor spinning results due to
not using HE detergent / using
excessive amount of detergent
There may be hot water inside
washer.
Door may not be closed
properly.
Door is not properly closed/
Door hinge is not aligned with
lock switch.
Excessive laundry might have
been loaded in.
Washing many items of the
same type or size of clothes
together.
Delay in unloading the washer.
Wrong program cycle might
have been selected.
Excessive laundry might have
been loaded in.
Solution
* Use the recommended
amount of detergent.
* Add more laundry (e.g. a
few additional towels) to the
drum and start a "Spin" or
"Spin&Drain" cycle.
* Use proper amount of HE
detergent.
* For safety reasons, water
should be cycled in and out
a couple times.
* Close the loading door.
* Check for excessive laundry
avoiding the door to be
closed. Push and/or shut the
loading door firmly until it is
properly closed.
* Do not load the washer in
excess.
* Load the wash drum with
items of different sizes.
* Unload the washer as soon
as the wash cycle ends.
* Select the proper program
cycle for the laundry to
be washed (See "Laundry
Tips" & "Program Cycle
Selection").
* Do not load the washer in
excess.
85 / English
Advertisement
Table of Contents
