Table of Contents
Advertisement
Troubleshooting
Problem
Loading door
cannot be
opened.
Washing takes
longer than
specified in the
manual.(*)
Owner's Guide & Installation Instructions
Reason
The cover lock is activated due
to the water level inside the
product.
Washer might be heating up
the water or it may be at the
spinning cycle.
Loading door may be stuck
because of the pressure it is
subjected to.
If there is no power, loading
door of the product will not
open.
Water pressure is low.
Supply voltage might be low.
Input temperature of the water
might be low.
Number of rinse cycles and/
or amount of rinse water might
have increased.
Excessive foam might have
occurred and the automatic
foam absorption system might
have been activated due to too
much detergent.
There may be an imbalance of
load in the drum.
Solution
* Drain the water by
running the Pump or Spin
programme.
* Wait until the process is over.
* Grab the handle and push
and pull the loading door to
release and open it.
* To open the loading door,
open the pump filter cap and
pull down the emergency
handle positioned at the rear
side of the said cap. See
"Door locking system"
* Product waits until taking
in an adequate amount
of water to prevent poor
washing quality due to the
decreased amount of water.
Therefore, the washing time
extends.
* Washing time is prolonged to
avoid poor washing results
when the supply voltage is
low.
* Required time to heat up
the water extends in cold
seasons. Also, washing time
can be lengthened to avoid
poor washing results.
* Product increases the
amount of rinse water when
good rinsing is needed and
adds an extra rinsing step if
necessary.
* Use the recommended
amount of detergent.
* The automatic spin
correction system might have
been activated due to the
unbalanced distribution of
the laundry in the drum.
77 / English
Advertisement
Table of Contents
