Table of Contents
Advertisement
Troubleshooting
Problem
Product vibrates
or makes noise.
There is water
leaking from the
bottom of the
washer.
Product stopped
shortly after
the programme
started.
Product directly
discharges the
water it takes in.
No water can be
seen in the drum
during washing.
76 / English
Reason
Product might be standing
unbalanced.
A hard substance might have
entered into the pump filter.
Transportation safety bolts are
not removed.
Laundry quantity in the
product might be too little.
Excessive laundry might be
loaded in the product.
Product might be leaning on a
rigid item.
Inlet hose connections may be
leaking.
End of the drain hose may be
loosely inserted into the waste
pipe or sink.
House drain may be clogged.
Filter cap of the drain pump
may not be properly fitted.
Hose connections inside the
washer may be leaking.
The machine might have
stopped temporarily due to
low voltage.
Draining hose might not be at
an adequate height.
Water is inside the invisible
part of the product.
Solution
* Stablize the product by
adjusting the feet.
* Clean the pump filter.
* Remove the transportation
safety bolts.
* Add more laundry to the
product.
* Take out some of the laundry
from the product or distribute
the load by hand to balance
it evenly in the product.
* Make sure that the product is
not leaning on anything.
* Be sure the strainers and
rubber seals of the water
inlet hoses are solid and
securely fitted.
* Tightly attach the drain hose
to the waste pipe or sink
(See "Installation Instructions,
Drainage").
* If the house drain pipes are
clogged, call a plumber for
assistance.
* Make sure that the pump
filter cap is tightly closed.
* Internal hose connections
(e.g. dispenser hoses, drain
system) should be checked
by a service technician.
* Product will resume running
when the voltage is restored
to a normal level.
* Connect the water draining
hose as described in the
operation manual.
* This is not a failure.
Front-Loading Automatic Washer
Advertisement
Table of Contents
