Settings - Varytec Hero Wash 300 FC User Manual

Operating

7.4 Settings

Hero Wash 300 FC
20
moving head
Use the 'Setting' menu to adjust the device parameters.
1.
Press [SET] to activate the main menu.
2.
Press [UP] or [DOWN] until the display shows 'Setting' and confirm the selec‐
tion with [SET].
3.
Press [UP] or [DOWN] to select the desired submenu or the desired value and
confirm the selection with [SET].
The following sub menus are available:
Menu level Menu level
2 3
'Pan Reverse' 'YES'
'NO'
'Tilt Reverse' 'YES'
'NO'
'Pan Limit' 'Starting
point'
'Ending
point'
'Tilt Limit' 'Starting
point'
'Ending
point'
'Home
Position'
'DMX Fail' Behaviour on DMX control failure
'Hold'
'Blackout'
'Auto Mode'
Menu level 4 Description
Pan reversal in opposite direc‐
tion of rotation is activated.
Pan reversal in normal direc‐
tion of rotation is activated.
Tilt reversal in opposite direc‐
tion of rotation is activated.
Tilt reversal in normal direc‐
tion of rotation is activated.
'0...539' Sets the starting point of the
rotation angle.
'1...540' Sets the ending point of the
rotation angle.
'0...239' Sets the starting point of the
tilt angle.
'1...240' Sets the ending point of the
tilt angle.
Setting the start parameters
Detailed information about
this menu item can be found
under Ä 'Setting the start
parameters' on page 23.
If the DMX control fails, the
last setting is retained.
If the DMX control fails, the
device is blacked out.
If the DMX control fails, the
"Automatic programmes"
mode is activated.