Summary of Contents for Horizon Hobby Axial SCX24 B-17 Betty
Page 1
AXI00004 INSTRUCTION MANUAL BEDIENUNGSANLEITUNG MANUEL D’UTILISATION MANUALE DI ISTRUZIONI...
Page 2
This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance.
WATER-RESISTANT VEHICLE WITH WATERPROOF ELECTRONICS Your new Horizon Hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many “wet conditions,” including puddles, creeks, wet grass, snow and even rain.
WET CONDITIONS MAINTENANCE • Drain any water that has collected in the tires by spinning them at high speed. With the body removed, place the vehicle upside down and pull full throttle for a few short bursts until the water has been removed. CAUTION: Always keep hands, fi...
• Always disconnect the battery after charging, and let the charger cool between charges. • Always charge in a well-ventilated area. • Always terminate all processes and contact Horizon Hobby if the product malfunctions. • Charge only rechargeable batteries. Charging non-rechargeable batteries may cause the batteries to burst, resulting in injury to persons and/or damage to property.
TRANSMITTER LAYOUT Use the diagram below to familiarize yourself with the different parts of your transmitter. The transmitter antenna is mounted internally and is located in the front portion of the transmitter. When you are driving your model, hold the transmitter so it is oriented as close to vertical as possible. Do not try to follow your model with the transmitter.
INSTALL THE TRANSMITTER BATTERIES 1. Press the battery compartment latch and rotate the batter cover to open. 2. Install 4 AA alkaline batteries (or Ni-Cd or Ni-MH), verifying correct polarity. 3. Close the battery cover until it latches. CAUTION: NEVER remove the transmitter batteries while the vehicle is powered ON.
POWER ON THE VEHICLE TEST THE CONTROLS With the vehicle wheels off the ground, test the throttle and steering controls. Ensure the wheels spin in the proper direction and the front wheels turn in the proper direction with steering input. After checking for proper direction of controls, start driving slowly.
AFTER DRIVING When you are fi nished driving your vehicle: 1. Power off the vehicle. 2. Power off the transmitter. 3. Remove the vehicle battery and charge if necessary. BINDING THE TRANSMITTER AND RECEIVER Binding is the process of programming the receiver to recognize a specifi c transmitter signal, thus preventing interference from other transmitters.
REQUIREMENTS OF THE PURCHASER’S INTENDED USE. modifi cation of or to any part of the Product, (iv) attempted Purchaser’s Remedy service by anyone other than a Horizon Hobby authorized Horizon’s sole obligation and purchaser’s sole and service center, (v) Product not purchased from an authorized...
Page 12
Service or replacement decisions are at the sole discretion Horizon is not responsible for merchandise until it arrives of Horizon. Proof of purchase is required for all warranty and is accepted at our facility. An Online Service Request claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER is available at http://www.horizonhobby.com/content/ THIS WARRANTY IS THE PURCHASER’S SOLE AND service-center_render-service-center.
800-338-4639 Hanskampring 9 Horizon Technischer Service service@horizonhobby.eu European D 22885 Barsbüttel, Union Sales: Horizon Hobby GmbH +49 (0) 4121 2655 100 Germany FCC INFORMATION FCC ID: XJ6MT-203 Supplier’s Declaration of Conformity frequency energy and, if not installed and used in...
COMPLIANCE INFORMATION FOR THE EUROPEAN UNION EU Compliance Statement: Axial SCX24 B17 Betty 1/24 Scale Electric 4WD RTR (AXI00004) Hereby, Horizon Hobby, LLC declares that Wireless Frequency Range and Wireless Output Power: the device is in compliance with the following: EU Radio 2405.0 –...