Table of Contents
Advertisement
DIFFERENT FUNCTIONS FOR THE MIDI PROTOCOL
Switching on the MIDI input function:
1)
Hold the RECORD/SHIFT button down.
2)
Press three times the flash button no. 1 in the PRESET A section.
3)
Release the buttons. The display shows now [Chl]
4)
Select via one of the flash buttons 1 to 12 in section PRESET B the pattern to which you wish to add the MIDI file.
Switching on the MIDI output function:
1)
Hold the RECORD/SHIFT button down.
2)
Press three times the flash button no. 2 in the PRESET A section.
3)
Release the buttons. The display shows now [Ch0].
4)
Select via one of the flash buttons 1 to 12 in section PRESET B the pattern from where you wish to switch on the MIDI
output function.
Switching off the MIDI in- and output functions
1)
Hold the RECORD/SHIFT button down.
2)
Press the REC/EXIT button once.
3)
Release both buttons. The display show now 0.00.
Downloading a MIDI control file:
1)
Hold the RECORD/SHIFT button down.
2)
Press three times the flash button no. 3 in the PRESET A section.
3)
Release both buttons. The display shows now [IN].
4)
While downloading the data, all running light functions are temporarily switched off.
5)
The control protocol downloads the data from address 55Hex under the file name DC1224.bin.
Uploading a MIDI control file:
1)
Hold the RECORD/SHIFT button down.
2)
Press three times the flash button no. 4 in the PRESET A section.
3)
Release both buttons. The display shows now [OUT].
4)
While uploading the data, all running light functions are temporarily switched off.
5)
The control protocol uploads the data to address 55Hex under the file name DC1224.bin.
Attention!
1. To retain your programs from loss, this unit must be powered not less than two hour every month.
2. The Segment Display shows "LOP" if the voltage is too low.
9
Advertisement
Table of Contents
