Table of Contents
Advertisement
ERASING A PROGRAMMED SPEED
1)
Switch off the music control.
2)
Select the required pattern via the PAGE button and the appropriate slider control of the section PRESET B. Set the slider
control completely to the top.
3)
Press the MODE SELECT button until the red LED lights up (CHASE-SCENES).
4)
Select the MIX CHASE mode via the PARK button (the yellow LED lights up).
5)
Push the slider control SPEED completely down.
6)
Hold the REC SPEED button down while pressing the flash button of the appropriate pattern. The fixed speed setting is
now erased.
CHANGING THE RANGE OF THE SPEED CONTROL
This slider control has two adjustable control ranges: 0.1 seconds to 5 minutes and 0.1 second to 10 minutes. Hold the
RECORD/SHIFT button down and press three times in sequence the flash button number 5 (from the top row) to set the range
to 5 minutes, or three times the flash button 10 for the 10 minutes setting. The selected range is indicated by the yellow LEDs
just above the SPEED control.
EXPLANATION OF SOME SPECIAL FUNCTIONS
Note: When the scene setter is switched on, the BLACK OUT function is automatically activated. All outputs are set to zero so
that the connected light effects do not work. Press the BLACK OUT button to leave this mode.
Fade time:
The FADE control sets the fading time between the different light positions.
Single Mode:
In single mode all running light programs will be played in sequence. Select the CHASE-SCENES mode via the MODE
SELECT button (red LED) and the SINGLE CHASE mode via the PARK button (yellow LED). Make sure that the audio control
is switched off. The SPEED control sets the speeds of all patterns.
Mix Mode:
Multiple play of the stored patterns. Select CHASE-SCENES via the MODE SELECT button (red LED) and MIX CHASE via the
PARK button (yellow LED). Make sure that the audio control is switched off and set the speed of the light effects individually via
the SPEED control.
Indications on the display:
The display shows the different settings and pattern numbers. You can choose between the display of the DMX value (0 to
255) or a percentage (0 to 100%) of the light setting. Hold the RECORD/SHIFT button down while pressing the INSERT/% or
0-255 button. Set one of the slider controls 1 to 24 in the upper position and check the display. If required, repeat these steps.
The minutes and seconds are indicated on the display by two dots. E.g. 12 minutes and 16 seconds are displayed as 12.16.. If
the time is below 1 minute, it is displayed by 1 dot e.g. 12.0 is 12 seconds and 5.00 is 5 seconds.
Blind function:
During automatic play of a running light pattern, it is possible to switch off a particular channel and to control that channel
manually. Hold the BLIND button down while pressing the flash button of the channel that you wish to switch off temporarily. To
switch the channel on again, proceed in the same way.
8
Advertisement
Table of Contents
