Fault
lights up.
flashes.
"E:30/-20"
All other error codes.
Cause and troubleshooting
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 34.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 31
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 25
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 55
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 55
Troubleshooting en
45