Table of Contents
Advertisement
en Troubleshooting
Fault
"E:30 / -10" and/or
"E:35 / -10"
flashes.
lights up.
44
Cause and troubleshooting
First wait approx. 5 minutes until the drain process
1.
ends.
To reset the error message, switch the appliance
2.
off.
Switch the appliance back on.
3.
If the error message is displayed again, call cus-
4.
tomer service.
→ "Customer Service", Page 55
There is water in the base trough.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 55
The appliance is leaking.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 55
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 37
Push in the detergent drawer until the symbol goes
2.
out.
The automatic voltage control system detects an un-
authorised voltage drop.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Advertisement
Table of Contents
