Subscribe to Our Youtube Channel
Related Manuals for Columbus IDV 60
Summary of Contents for Columbus IDV 60
- Page 1 IDV 60 Operating manual Industrial vacuum cleaner Read these This machine is instructions carefully intended for before operating the industrial and machine! professional use only!! 01.2022...
- Page 2 This manual should be considered an integral part of the vacuum cleaner and must be kept together with the unit until this is scrapped. In case of loss of or damage to the manual, ask columbus for a new copy.
-
Page 3: Table Of Contents
Industrial vacuum cleaner IDV 60 Contents 1 Information ............................4 1.1 Identification of the main parts ....................... 4 1.2 Accessories provided ........................5 1.3 Identification details of manufacturer ..................... 6 1.4 Type plate ............................6 1.5 Intended uses ..........................7 1.6 Allowed environmental conditions .................... -
Page 4: Information
Industrial vacuum cleaner IDV 60 1 Information 1.1 Identification of the main parts 1) Suction head 2) Release fastening 3) Push handle 4) Filtering chamber 5) Filter shaking lever 6) Removable vacuumed material container 7) Fixed wheels 8) Castors 9) Suction inlet... -
Page 5: Accessories Provided
Industrial vacuum cleaner IDV 60 1.2 Accessories provided 21476900 – POLYESTER FILTER CAT. “L” Ø500 H400 14T... -
Page 6: Identification Details Of Manufacturer
Industrial vacuum cleaner IDV 60 1.3 Identification details of manufacturer G. Staehle GmbH u. Co. KG columbus Reinigungsmaschinen Merce72sstr.15 D - 70339 STUTTGART Telefon +49(0)711 / 9544-950 info@columbus-clean.com www.columbus-clean.com 1.4 Type plate In compliance with the Machine Directive 2006/42/CE on vacuum cleaners, the machine is fitted with CE plates. -
Page 7: Intended Uses
Industrial vacuum cleaner IDV 60 1.5 Intended uses These specific vacuum cleaner models have been designed, built and protected for vacuuming dusts and solid materials only, using special filters. Warning! Always use specific filters for the type of dust or materials to be vacuumed. -
Page 8: Technical Details
Industrial vacuum cleaner IDV 60 1.10 Technical details Power 3,45 Voltage Volt 230-50/60 Max. vacuums rate mm / H 2.500 Max. air flow rate m³ / h Noise level dB (A) Filter type Polyester Filter surface cm² 20.000 Capacity Suction inlet Ø... -
Page 9: Safety
They should also have the tools necessary to perform these duties properly. columbus shall under no circumstances be deemed liable for accidents or damage caused by use of the vacuum cleaner by personnel not properly trained or who use it in an improper manner, as well as by even partial failure to comply with the safety regulations and intervention procedures indicated in this manual. -
Page 10: Safety Warnings
Industrial vacuum cleaner IDV 60 2.2 Safety warnings Attention! The following indications are, by themselves, not enough to fully protect against all the hazards that could arise during vacuum cleaner operation. These will have to be integrated with common sense and the experience of the operator, both of which are crucial factors for preventing accidents. - Page 11 Exploded Spare Parts drawing, Declaration of Conformity. In the event of Customers fitting a tool to the machine not supplied by columbus, make sure the safety conditions required by Machine Directive 2006/42/CE are complied with and in any event, columbus is unable to accept liability for any problems arising from use of such tool.
- Page 12 Industrial vacuum cleaner IDV 60 Climbing on the cleaner is forbidden. Never touch electric wires, switches, buttons, etc. with wet hands. Before connecting to the power mains, make sure the power voltage and frequency are those shown on the machine plate.
-
Page 13: Safety Plates And Symbols
Clean these with a cloth, soap and water. Do not use solvents, diesel fuel or petrol. Replace the damaged plates with new ones supplied by columbus. If a plate is affixed to a replaced part, make sure a new plate is affixed to the new part. -
Page 14: Outstanding Risks
Industrial vacuum cleaner IDV 60 2.4 Outstanding risks Careful analysis of risks performed by the manufacturer and stored in the technical file has made it possible to eliminate most of the risks associated with vacuum cleaner operation. The manufacturer advises carefully following the instructions, procedures and advice contained in this manual as well as applicable safety regulations, including the use of the envisaged protection devices, both those integrated in the cleaner and individual. -
Page 15: Installation
Industrial vacuum cleaner IDV 60 3 Installation 3.1 Handling Weight (incl. packaging) (cm) (cm) (cm) IDV 60 The machine is supplied in a strong cardboard box secured with straps. Transport the package using a fork-lift truck of adequate lifting capacity and make sure it is stable and that weight is properly distributed on the forks. -
Page 16: Installation
Industrial vacuum cleaner IDV 60 3.2 Installation Warning! Before installing the vacuum cleaner, carefully make a sight check to pinpoint any damage suffered during transport. In the event of any component parts being damaged, do not proceed with installation. Notify the manufacturer and reach an agreement on how to proceed. - Page 17 Industrial vacuum cleaner IDV 60 Fit the supplied pipe on the connector. Make sure the power supply corresponds to the voltage and frequency indicated on the vacuum cleaner plate. Warning! Do not fit the plug in the power socket with wet hands.
-
Page 18: Operation
Industrial vacuum cleaner IDV 60 4 Operation 4.1 Description of controls 1) START/STOP switch motor 1 2) START/STOP switch motor 2 3) START/STOP switch motor 3 4) Red light POWER ON 5) Vacuum meter... -
Page 19: Work Cycle
Industrial vacuum cleaner IDV 60 4.2 Work cycle Warning! Before fitting the plug, make sure the power voltage corresponds to that on the CE marking plate. Make sure the power plug is correctly fitted in the power socket. Make sure the flexible hose is properly fitted and locked in the vacuum pipe union. - Page 20 Industrial vacuum cleaner IDV 60 To move the vacuum cleaner, use the large handle. Warning! The vacuum can be moved only on flat ground! If the vacuum is moved on inclined grounds, you can risk to lose the control, because of the weight and to damage persons or things.
-
Page 21: Releasing And Removing The Removable Container
Industrial vacuum cleaner IDV 60 4.3 Releasing and removing the removable container Stop the vacuum motors by pressing the relevant STOP buttons. Warning! Disconnect the plug from the power socket. Lift the lever located in the bottom part of the cleaner to release and remove the container. -
Page 22: Using The Filter Shaking System
Industrial vacuum cleaner IDV 60 4.4 Using the filter shaking system This operation must only be performed with the machine switched off once the motor has come to a complete halt. The filter shaking system is best operated every time before use and after prolonged operation. -
Page 23: Maintenance
Industrial vacuum cleaner IDV 60 5 Maintenance 5.1 Informative notes This section describes the control and special maintenance operations crucial for keeping the vacuum cleaner in perfect working condition. Any other jobs which might be necessary to eliminate operating faults must be expressly authorised by the manufacturer. -
Page 24: Maintenance Operations
If the flexible hose is perforated, the power of the cleaner will be reduced and dust and liquids will leak into the environment. Warning! All maintenance and repair jobs must be performed directly by columbus or its authorised dealers. -
Page 25: Replacing The Filters
Industrial vacuum cleaner IDV 60 5.4 Replacing the filters To replace the filters, proceed as follows: Turn off the vacuum cleaner by pressing the motor STOP buttons. Disconnect the vacuum cleaner plug from the power socket. Important! Wear individual protection devices. - Page 26 Industrial vacuum cleaner IDV 60 Remove from underneath the vacuum cleaner the pin (A) and spring pin (B) that fasten the filter to the shaking lever. Lift the filter complete with support. Loosen the clamp and remove the support ring with seal.
- Page 27 Industrial vacuum cleaner IDV 60 Important! All the material trapped by the filter and the filter itself must be disposed of through authorised channels in the country where the vacuum cleaner is used. The container locking operation must be performed by one person only, who must lower the back side lever with both hands.
-
Page 28: Troubleshooting
Check the seals and, if Seals worn necessary, replace it. Check for any air leaks out of closing fasteners, tightening Airleak screws, container or filter chamber. Motor very noisy Contact columbus after-sales. Warning! For any other problems, contact the columbus after-sales service. -
Page 29: Recommended Spare Parts
Industrial vacuum cleaner IDV 60 6 Recommended spare parts Code Description 21480600 ADHESIVE GASKET 10 X 30 21476900 "L" CAT. POLYESTER FILTER, 14T. Ø 500 FILTER HOLDING RING SHEATH Ø 500 21479100 FILTER CLAMP Ø 500 21487000 W1150 V240 50/60 HZ BP MOTOR... -
Page 30: Declaration Of Conformity
Industrial vacuum cleaner IDV 60 7 Declaration of conformity in accordance with the EC Directive on Machines 2006/42/EC Manufacturer G. Staehle GmbH u. Co. KG columbus Reinigungsmaschinen Mercedesstraße 15 D-70372 Stuttgart hereby declares that the following product conforms to the regulations of the above mentioned directive –... - Page 31 Industrial vacuum cleaner IDV 60...
- Page 32 G. Staehle GmbH u. Co. KG columbus Reinigungsmaschinen Mercedesstr.15 D - 70372 STUTTGART Telefon +49(0)711 / 9544-950 info@columbus-clean.com www.columbus-clean.com...
Need help?
Do you have a question about the IDV 60 and is the answer not in the manual?
Questions and answers