Furuno MU-152HD Operator's Manual page 26

1. MOUNTING, WIRING
1
* : Slide switch
Referring to below table to set the slide switch according to your vessel's configuration.
Slide Switch Inputs
ON (Factory de- Digital input
fault) (DVI, HDMI)
OFF Analog input
(RGB)
Note: Turn the slide switch off when you connect equipment to both the DVI, HDMI and RGB
ports.
2
* : BRILL CTRL port
Remove the sticker from the BRILL CTRL port, then connect the USB cable.
How to fix the composite signal cable
Fix the cables for the composite signal at the fixing terminal with the cable tie, to prevent a loose
connection.
1. Pass the cable tie (supplied) through the side of the fixing terminal.
2. Set the cable in the cable tie and pull the tie.
3. Cut off the excess cable tie with nippers.
Back of the display unit
Connected devices
• Radar
• Plotter
• Fish finder
• Scanning sonar
• Current indicator
Fixing terminal
17
Upward: Default setting Upward: Default setting
(Slide switch ON) (Slide switch ON)
Downward Downward
(Slide switch OFF) (Slide switch OFF)