I I nstalling 4-cell battery
1
Insert the battery into the slot on the computer.
2
Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
NOTE:
Route the battery cable, if the cable at the base of the battery is un routed.
3
Replace the M2 x 5 screws (2) to secure the battery to the computer.
4
Install the
base cover
5
Follow the procedure in
PCIe Solid State Drive (SSD)
Removing PCIe SSD
1
Follow the procedure in
2
Remove the :
a
base cover
b
battery
3
To remove the PCIe SSD:
a
Loosen the M2 x3 captive screw that secure the SSD bracket [1].
b Remove the SSD bracket [2].
c
Remove the PCIe SSD from the connector on the system board [3].
12
Removing and installing components
After working inside your
computer.
Before working inside your
computer.