Technical Safety - Miele PDW 909 SOM Quick Start Manual

Commercial washer-dryer stack
Hide thumbs Also See for PDW 909 SOM:
Table of Contents

Advertisement

Available languages

Available languages

Technical safety

Before setting up the washer-dryer stack, check it for any extern-
ally visible damage. Do not install or use a damaged washer-dryer
stack.
The electrical safety of this washer-dryer stack can only be guaran-
teed when correctly earthed. It is essential that this standard safety
requirement is observed and regularly tested. If in any doubt, please
have the electrical installation inspected by a specialist. Miele cannot
be held liable for the consequences of an inadequate earthing sys-
tem.
Unauthorised repairs could result in unforeseen dangers for the
user, for which the manufacturer cannot accept liability. Repairs
should only be undertaken by a Miele authorised technician, other-
wise any subsequent damage will not be covered by the warranty.
Do not make any alterations to the washer-dryer stack, unless au-
thorised to do so by Miele.
Disconnect the washer-dryer stack from the power supply in the
event of a fault and for cleaning and maintenance. The washer-dryer
stack is only electrically disconnected from the power supply when:
- Both washer-dryer stack plugs have been disconnected from the
socket or
- The mains fuses for both machine parts are disconnected or
- The mains fuses for both machine parts have been completely re-
moved.
See "Installation and connection – Electrical connection".
The washing machine may only be connected to the water supply
using the set of hoses supplied with the machine. Old sets of hoses
must not be re-used. Check the sets of hoses regularly for signs of
wear. Change the sets of hoses in good time to avoid the risk of leaks
and subsequent water damage.
The cause of any leaks must be dealt with before the washer-dryer
stack is restarted. Disconnect the washer-dryer stack immediately if
any water leaks out.
Faulty components must only be replaced by genuine Miele spare
parts. Miele can only guarantee the safety standards of the machine
when Miele spare parts are used.
All relevant national provisions and regulations (DGUV in Germany)
relating to accident insurance are applicable to this washer-dryer
stack. It is recommended to carry out testing in accordance with the
regulatory framework described in DGUV 100-500/Chapter 2.6/Sec-
tion 4. The test book required for the documentation is available from
the Miele Customer Service Department.
en - Warnings and safety notes
69

Advertisement

Table of Contents
loading

Table of Contents