A Fault Message Appears In The Display - Miele WT 2798 i WPM Operating Instructions Manual

A fault message appears in the display

Message
Fault
Check drainage
2
system
Fault
Water intake
2
Open stopcock
Waterproof system
activated
L
Close the stopcock
Technical fault
Call Service.
;
Check detergent
Hygiene info
A To delete the message from the display switch the machine off using the On/Off
button K.
Possible cause
– The water outlet is
blocked or
restricted.
– The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The water protection
system has reacted.
There is a fault.
Excessive foam has
built up during
washing.
See "Cleaning the drum (Hygiene info)" in "Cleaning
and care" for further information.
Problem solving guide
Remedy A
– Clean the drain filter and
the drain pump as
described in "Problem
solving guide – Opening
the drum door in the event
of a blocked drain outlet
and/or power failure".
– The maximum delivery
head is 1 m.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
– the filter in the water inlet is
clogged.
– If the fault message
appears again, contact the
Miele Service Dept.
– Close the stopcock.
– Contact the Miele Service
Department.
Start the programme again.
If the fault message appears
again, contact the Miele Ser-
vice Department.
Use less detergent next time
and follow the manufacturer's
instructions on dosage given
on the packaging.
57