Hyundai HSEN40V-A Original Instructions Manual page 4

- If the cutting mechanism strikes any foreign objects or
if the machine should start making any unusual noise
or vibration, immediately shut off the power source
and allow the machine to stop. Remove the battery
from the machine and take the following steps
before restarting and operating the machine:
o inspect for damage;
o replace or repair any damaged parts;
o check for and tighten any loose parts.
- Never operate the machine with defective guards
or shields, or without safety devices
- Keep the power source clean of debris and
other accumulations to prevent damage to the
power source or possible fire.
- Do not transport this machine while the power source
is running.
- Stop the machine, and remove the battery. Make
sure that all moving parts have come to a complete
stop
o whenever you leave the machine,
o before clearing blockages or unclogging chute,
o before checking, cleaning or working on the
machine.
- Do not tilt the machine while the power source is
running.
Maintenance and storage
- When the machine is stopped for servicing,
inspection, or storage, or to change an accessory,
shut off the power source, remove the battery and
make sure that the machine is come to a complete