Hyundai HSEN40V-A Original Instructions Manual page 17

INSTALLING BATTERY PACK
See Figure 3.
Place the battery pack in the blower's battery port. Align the raised rib on the
■
battery pack with the groove in the blower's battery port.
Make sure the latch on bottom of the battery pack snaps in place and that
■
battery pack is secured in the blower before beginning operation.
When placing battery pack in the blower, be sure the raised ribs on the
battery pack align with the grooves in the top of the blower. Make sure
the battery is fully seated, and it latches into place properly. Improper
installation of the battery pack can cause damage to internal
components.
REMOVING BATTERY PACK
See Figure 3.
Release the trigger to stop the blower.
■
Press and hold the latch button at the bottom of the battery pack.
■
Remove battery pack from the blower.
■
CHARGING THE BATTERY
Align the raised rib on the battery pack with the groove on the battery charger.
■
Plug the charger to the electrical alimentation.
You can see the charge status by pressing the charge level indicator which is on
■
the battery. The battery is fully charged when all light are switched on.
STARTING /STOPPING THE BLOWER
See Figure 4 and Figure 5
To start the blower, Press the lock button and push the trigger
■
To stop the blower, release the trigger.
■
Battery tools are always in operating condition. Therefore, operation
trigger switch should always be in the OFF (released) position when not in
use or carrying/ moving the tool.