Table of Contents
Advertisement
11. Open Advanced tab, and then Multipath Reduction subtab. Activate Code multipath
reduction on base and rover for DGPS mode. For RTK mode activate Carrier
multipath reduction as well.
12. Click Apply, to save the made changes and settings into receiver's memory and close
the dialog window. The receiver configuration will be kept in the receiver until changed or
the NVRAM is cleared.
Note: For detailed description of settings and parameters, please see the NetView&Modem Software Manual.
Figure 13: Parameters – Advanced – Multipath Reduction
Page 25 of 35
Advertisement
Table of Contents
Need help?
Do you have a question about the TRIUMPH-3NR and is the answer not in the manual?