Javad TRIUMPH-3NR User Manual page 14

3.2.2. Power on/off
To turn TRIUMPH-3NR on:
Press and hold the PWR button for about 2 sec. (the LED will blink blue; this means the
•
power button is active).
Release the PWR button. The PWR LED will flash yellow (device turning on). Then SAT
•
and POS LEDs will flash red/yellow/green several times (system is loading).
Wait until the PWR, SAT and POS LEDs stop blinking. The PWR will constantly stay with
•
the color from the table above. The rest of LEDs will work according to their status.
Note: If after pressing PWR button the PWR LED flashes several times red and turns off, this means the battery is
discharged.
To turn TRIUMPH-3NR off:
Press and hold the PWR button for 2 sec. (the LED will flash yellow).
•
The device will turn off by itself.
•
For a long life of internal battery pack with a long life, use the JAVAD supplied power cables and
Power Charger that came with the unit.
3.2.3. Device Charging
A single external power supply with a 3.5mm DC connector or SAE connector is necessary to
operate the TRIUMPH-3NR. If external power supply has only an SAE connector, the Receiver-
to-SAE power cable is be used. The external power supply needs to be approved for the US and
EU, and have an output rated for 10 - 30 V DC, 3A. This may not be the same range as other
JAVAD GNSS products. To avoid the introduction of hazards when operating and installing,
before connecting the TRIUMPH-3NR to the supply, make sure that the supply meets local and
national safety ordinances and matches the equipment's voltage and current requirements.
Warning: Never attempt any maintenance or cleaning of the supply while plugged in. Always remove supply from AC
power before attempting service or cleaning.
If the voltage supplied is below the minimum specification, the receiver will suspend operation. If
the voltage supplied is above the maximum specification, the receiver may be permanently
damaged, voiding your warranty.
Make sure cords are located so that they will not be stepped on, tripped over, or otherwise
subjected to damage or stress. Do not operate the TRIUMPH-3NR with a damaged cord or plug
– replace immediately. To reduce the risk of damage to the TRIUMPH-3NR, pull by the plug
body rather than the output cord when disconnecting the equipment.
Warning: Do not operate the power supply if it has received a sharp blow, been dropped, or otherwise damaged. Do
not disassemble the power supply.
The TRIUMPH-3NR comes from the factory with the batteries charged and ready to use so you
can begin exploring its interface and familiarizing yourself right away while reading this manual.
To check the status of the internal battery pack, view the BAT LED or check the status using
JAVAD GNSS software. When the TRIUMPH-3NR is turned off and charging, the BAT LEDs will
keep you apprised of its charging progress.
Page 14 of 35