Configuration Instructions - UP3D F20 User Manual

The definition of each box and the value range of input parameter are shown in the
following table:
t1 The first stage heating rate , valid value range: 5-20℃ /min
The target temperature of the first stage, the effective value range:
T1
300 ℃-500 ℃
t2 The second stage heating rate , valid value range: 5-15℃ /min
The target temperature of the second stage, the effective value
T2
range: 900℃-1200℃
H2 Second stage holding time, valid value range: 0-30min
t3 The third stage heating rate, valid value range: 2-10℃ /min
The third stage target temperature, effective value range:
T3
1250℃ -1400℃
H3 The third stage of holding time, effective value range: 0-30min
t4 The fourth stage heating rate, valid value range: 2-10℃ /min
The fourth stage target temperature, effective value range:
T4
1450℃-1600℃
H4 Fourth stage holding time, effective value range: 0-300min
t5 Cooling rate, effective value range: 5-10℃ /min
Control the temperature for stopping cooling, effective value range:
400℃-1000℃
(Notes: If the input temperature is between 800°C-1000°C, the
T5
cooling will be according to the cooling rate; If lower than 800°C,
after the fourth stage of heat preservation, the heating will be
stopped and will not control the cooling rate, the cooling will be
according to natural cooling.)
3.2 Configuration Instructions
1. Function configuration of F20 smart sintering furnace:
Sintering 20 programs can be freely set by the user Easy to search
program
when sintering
Number of Three layers of sintering tray can be placed at the same
crucibles time
Furnace
Lifting open type
mode
13
Heating
Heating evenly on all sides
method
Maximum
heating 1600℃
temperature
Temperature
measuring Type B thermocouple
element
Heating
Four ultra-pure silicon molybdenum rods
element
Operation
7 inch true color touch screen
mode
Short-time
If the temperature drops less than 150 ° C during power
power off but
off, the sintering can be automatically continued when the
continuous
power on.
burning
Hearth down
After cooling down to 800 ℃ , the hearth automatically
automatically
goes down.
during cooling
Increase the cooling rate and save the sintering time.on.
Large words on the screen saver displays the remaining
time of sintering, the real-time temperature of the furnace,
Screen saver
popup and automatically adjustment of the target temperature,
which can be observed at a distance.
When a fault occurs, a pop-up window can be displayed
Trouble in time to show the fault code, and the corresponding
popup problem of the fault code can be found on the screen
warning page, which is convenient for maintenance.
False triggering If any misoperation, sintering recovery can be carried out
recovery when the temperature drops less than 150℃.
2. Basic factory configuration of sintering curve: (for reference only)
Program code Description
P01 UPCERA ST single crown
P02 UPCERA ST short bridge
P03 UPCERA ST long bridge
P04 Xiangtong, less than 5 units
P05 Xiangtong, more than 5 units
14