UP3D F20 User Manual page 5

3.1.4 Interface Operation
1) Sintering control button:
when the hearth is not raised to the proper position or there is a faulty pop-up, the
button cannot be activated for sintering; Otherwise, when click the sintering control
button, the triangle on it will turn into two vertical lines and the sintering will start;
then click it again, the two vertical lines will turn into triangle, and the sintering will be
stopped.
click
2) Fault display box:
Click on the fault display box, and a fault code table will pop up. When the fault code
pops up during the use of the F20 sintering furnace, fault cause can be found out
from this fault code table, and the fault can be solved according to the corresponding
solution.
05
click
again
3) Setting box:
Click the setting box to pop up the circuit calibration and setting password box. The
circuit calibration module is only open to the technical support of UP3D TECH. A
password is set for the customer to manage the defined sintering program, prevent-
ing others from tampering with the defined program.
Data reset and temperature calibration are not available, please contact the techni-
cian if you need to operate.
Click the Enter password box to enter the password input interface.
06