LG ROBOKING VR668 V Series Owner's Manual page 8

Table of Contents

Advertisement

SAFETY PRECAUTIONS
CAUTION
If the floor is wet or has wet
spots, wipe them up before
using the Robot Cleaner. Do
not use the Robot Cleaner on a
wet surface.
Doing so can cause product
failure.
When attaching the mop,
ensure that it is fitted correctly
so that it does not block the
lower camera sensor.
Blocking the bottom camera
sensor may not allow the
product to work correctly.
To save energy when the Robot
Cleaner is not in use for longer
periods, turn off the power
switch, and turn on the power
switch again just prior to using
the Robot cleaner again.
Tip
Check the following items before use:
• Empty the dust bin after each operation or prior to it filling up.
• Remove any cables or long strings from the floor.
• Remove any moisture from the floor before cleaning.
• Close the cover of the dust bin before cleaning.
• Remove fragile or unnecessary objects from the room to be cleaned.
For example, remove expensive ceramics and valuables from the floor.
• Confirm whether the battery has sufficient power, and if it is low, recharge it.
• Close the doors of any room that you do not want the Robot Cleaner to enter.
During cleaning, the Robot Cleaner may enter another room and continue cleaning.
• Do not use this product in the room where a child is sleeping alone. The child can be
hurt or woken.
• Remove towels, foot towel or any other thin cloth from the floor as they can get caught
by the brush.
• Before starting the device, it's better to remove carpets that are thicker than 20 mm as
they may cause it to malfunction.
• Please close any balcony doors as the wheels may get stuck while cleaning.
• Please install the mop board since climbing low heights, such as bottom of a standing
electric fan, may cause damage to the robot cleaner.
• Connecting to a wireless router without proper security setup may cause security issues.
• If security is set up internally for your organization, it may affect connection therein.
6
When the robot cleaner is
operating, it may hit the chair
leg, desk leg, table leg or other
narrow pieces of furniture.
For quicker and better cleaning,
place the dining chairs on top
of the dining table.
NOTE: Very low thresholds will
allow the Robot cleaner to go
over them and perhaps into an
undesirable location. Make sure
that all the doors of the rooms
that are not to be cleaned are
closed. Oddly shaped and
sized thresholds can cause the
cleaner to become stuck. This
is not a malfunction.

Advertisement

Table of Contents
loading

Table of Contents