Conversion From Lp Gas To Natural Gas; Make Gas Connection - KitchenAid 870-0003C Installation Instructions And Use & Care Manual

Parts supplied
◼
Natural gas orifices
Parts needed
◼
Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:
(NOT INCLUDED WITH APPLIANCE)
◼ Natural gas regulator 4" W.C. (marked "Natural Gas
Regulator")
◼
3.0 m / 10 ft Natural gas hose with quick connector
◼
150 mm / 5.9 in Natural gas regulator hose
◼
6 mm nut driver
◼
6 mm wrench
◼
Hex key
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the grill.
Conversion from LP Gas to
Natural Gas
Installation of the regulator
1. Turn off the main gas supply valve.
2. Disconnect 9.07 kg (20lb) LP gas fuel tank (if present).
3. Turn off all burner control valves.
4. Remove the 9.07 kg (20lb) LP gas fuel tank (if present)
from the grill cart.
5. Use an adjustable wrench to remove the LP regulator from
the manifold.
6. Use an adjustable wrench to install the Natural gas
regulator hose to the manifold and secure. Attach the
Natural gas regulator to the side panel inside the grill cart
with the two screws that are preassembled on the
regulator.

Make Gas Connection

1. Before making any connections, check to ensure the
natural gas inlet pressure falls between the allowable
range of 7" W.C. / 0.25 psi and 14" W.C. / 0.5 psi. If the
NG inlet pressure does not fall within this range, contact
your local gas supplier.
2. A combination of pipe fittings must be used to connect the
grill to the existing gas line.
◼
The 3.0 m / 10 ft PVC flexible gas supply hose design
certified by CSA must be used.
◼
Pipe-joint compounds suitable for use with Natural
gas must be used. Do not use Teflon®+ tape.
◼
There must be a certified manual shut-off valve in the
gas supply line near the grill for easy access.
3. Connect the brass connector on one end of the 3.0 m / 10
ft PVC flexible gas supply hose to the Natural gas pressure
regulator.
4. Connect the quick connector on the other end of the 3.0 m
/ 10 ft PVC flexible gas supply hose to the rigid Natural gas
supply pipe.
Change Grill Main Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the 2 screws and cotter clip that hold the burner in
place. Set the screw and clip aside.
† ®TEFLON is a registered trademark of Chemours.
26