Product Function - VEVOR XMZ-D1 Manual

other flammable objects.
4. Do not use cigarette lighter for startup.
5. Do not use the heater in closed and/or unventilated places.
6. The heaters shall be turned off when filling fuel.
7. Do not cut off the electric power in operation.
8. If the fuel leak or discharge from the fuel system of heaters, please contact with
VEVOR to repair.
9. Place the exhaust outlet outside to prevent any penetration of exhaust fumes.
10. In the process of work, it is forbidden to cut off the electric power directly to
stop the heater from working.
11. Seal all gaps between the mounting plate and the car body.
12. The machine will stop heating after over-temperature protection. Please do
not power off. After the machine is naturally cooled and turned off, it can be
restarted.
13. After turning off the machine, please do not immediately disconnect the power
supply. It takes 3-5 minutes for the machine to stop working completely.
14. After starting the machine for 3-5 minutes, it will work normally and heat up.
Please wait patiently.
15. When the heater is just started, the current is relatively high, so an adapter
with a voltage of 12V and a current of 15A or greater is required for the power
supply.
The diesel heater (hereinafter referred to as the heater) is independent of the
1.
original engine system. It makes use of a 12V direct current to drive. There are two
kinds of control modes for the heater: Automatic control mode and Manual control
mode. The heater adopts light diesel which corresponds to the environmental
temperature as fuel, and it can be started and operated normally at the
temperature of above-40N. The inhaled fresh air is heated to hot air through the
heat exchanger by the energy which comes from fuel burning, then blown to where
it is needed. This type of heater owns the advantage of compact structure, light
weight, high thermal efficiency, economize on electricity and fuel, and easy

PRODUCT FUNCTION

- 4 -