Cutting With The Rip Fence - Ryobi RTBS18X Manual

CUTTING WITH THE RIP FENCE

1. Lift the rip fence's lock lever. Lower the
front end of the rip fence to the front edge
of the worktable. Then lower the rear end
of the rip fence to the rear edge of the
worktable. Apply force to the rear edge
of the rip fence and adjust the rip fence's
position. Do not adjust by the lock lever.
2. Lower the lock lever to fix the rip fence in
place. NOTE: Ensure that the rip fence is
parallel to the saw blade.
3. Place the workpice on the work table
against the rip fence. Feed the workpiece
using the push stick as aid.
WARNING! Use the push stick between
the blade and rip fence. Do not use at the
open end.
WARNING! Do not perform cutting
operation freehand.
1
1
3
2
3
5
4
2
Operation
13