Cutting With The Rip Fence - Ryobi RBS250G Manual

ADJUSTING THE BLADE GUIDE ASSEMBLY
Loosen the blade guide assembly lock knob
to unlock the blade guide assembly. Turn the
blade guard adjustment knob to raise or lower
the blade guide assembly. The blade guide
assembly should be about 3-4 mm above the
workpiece. Tighten the blade guide assembly
lock knob.

CUTTING WITH THE RIP FENCE

1. Disconnect the product from the power
outlet. Lift the rip fence's lock lever. Lower
the front end of the rip fence to the front
edge of the work table. Then lower the
rear end of the rip fence to the rear edge
of the work table. Apply some force to the
rear edge of the rip fence toward the work
table, and adjust the rip fence's position.
Do not adjust by the lock lever.
2. Lower the lock lever to fix the rip fence in
place. NOTE: Ensure that the rip fence is
parallel to the saw blade.
3. Place the workpice on the work table
against the rip fence. Feed the workpiece
using the push stick as aid.
WARNING! Do not perform cutting
operation freehand. Use additional support
for long workpieces.
1
2
2
1
2
2
1
3-4 mm 3-4 mm
1
Operation
3
15