Pre-Operation - BorMann Lite Series Manual

The inlet pipe should at least 5 M long. Do not use the pipe if the pipe is damaged.
Machine not suitable for connection directly to the potable water mains.
WARNING! Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly qualified person to
avoid a hazard.
Connection
1. Attach the high pressure hose to the pressure water outlet of the machine.
2. Attach the spray handle to the high pressure hose. Prior to operating the machine please ensure that the high pressure
hose has been completely uncoiled. Whilst the machine is in operation the hose MUST not loop.
3. Mount the nozzle or any other equipment you want to use.
4. Connect the machine to the water and power supplies.
Installation, electrical and water connections
1. Pressure cleaner
2. Water supply hose
3. Water connection
4. Water inlet
5. High pressure tube
6. Water outlet
7. Spray gun
8. Power supply
* No. 2, 3, 8 are not included

Pre-operation

Adjusting fan pattern
The angle of spray coming out of the lance may be adjusted on some lances by rotating the nozzle. This will vary the spray
pattern from approximately a 0° narrow high impact stream to a 60° wide fan spray (See Figure 2).
5