Unità A Stato Solido; Unità A Stato Solido (Metà Lunghezza) - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Unità a stato solido
Unità a stato solido (metà lunghezza)
Removing the M.2230 solid-state drives
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
About this task
The following image indicates the location of the M.2230 solid-state drives and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3.5) that secures the M.2230 solid-state drive to the system board.
2. Slide and lift the M.2230 solid-state drive from the M.2 card slot on the system board.
Installing the M.2230 solid-state drives
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: If you are replacing a M.2 2280 solid-state drive with a M.2 2230 solid-state drive, ensure the M.2 2280 solid-state
drive is removed first.
56 Rimozione e installazione delle unità sostituibili dal cliente (CRU)
Before working inside your
if applicable.
if applicable.
cage.
computer.