Compatible Cartridges - Hilti DX 351-CT Manual

• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.

Compatible cartridges

Ordering designation
6.8/11 M green
6.8/11 M yellow
6.8/11 M red
3.4 Information about the field of applications
See the Hilti product page for more information about the areas of application.
4 Technical data
4.1 Product properties
Weight (basic tool)
Length (fastening tool)
Recommended maximum fastening
rate
Required contact pressure
Compression stroke
Ambient temperature (storage and
use)
4.2 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Min. distance to edge
(base-material edge to fastener)
Min. center-to-center distance
(between fasteners)
Min. base material thickness
*388037*
DX 351-CT
2.7 kg
(6.0 lb)
545 mm
(21.5 in)
700 fastener driving operations/h
140 N ... 320 N
(31 lb ... 72 lb
f
62 mm
(2.4 in)
−15 ℃ ... 45 ℃
(5 ℉ ... 113 ℉)
Concrete
≥ 70 mm
(≥ 2.8 in)
≥ 80 mm
(≥ 3.1 in)
≥ 100 mm
(≥ 3.9 in)
388037
Color
green
yellow
red
)
f
Steel supporting structures
≥ 15 mm
(≥ 0.6 in)
≥ 20 mm
(≥ 0.8 in)
Follow the instructions in the
operating instructions of the
fastener!
Power level
Weak
Medium
Strong
English 5