Move Unit Manually - Gravely Pro-Turn Z52 Operator's Manual

Direction Lever Position
of Travel
Left Turn Push right lever
farther forward
than the left lever.
Stop Return both
levers to neutral
position.
IMPORTANT: Aggressive turning can scuff or
damage lawns. Always keep both wheels
rotating when making sharp turns. DO NOT
make turns with inside wheel completely
stopped. For minimum turning radius, slowly
reverse inside wheel while moving outside
wheel slowly forward.
For Best Mowing Results
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Adjust anti-scalp wheels to prevent
scalping.
• Do not set height of cut too low. For very
tall grass, mow twice.
• Do not travel too fast.
• Mow with the engine set at full throttle.
• When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
2.5 cm (1") at any one time.
• Discharge clippings into areas already cut.
• Vary cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside of mower deck. Clean after each
use.Stop the Engine
WARNING: AVOID INJURY.
Wait for all moving parts to
stop before leaving operator's
position.
1. Place steering levers in neutral position
and rotate outward.
2. Engage parking brake.
3. Push PTO knob down to off position.
4. Set throttle to slow speed.
5. Turn ignition key to off position and
remove key.

MOVE UNIT MANUALLY

Bypass the transaxles to move the unit with
the engine off.
IMPORTANT: There is one transaxle bypass
lever on each side of unit. Ensure that both
levers are fully in front or rear position.
1. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool. See Do not allow grass or debris to
collect inside of mower deck. Clean after
each use.Stop the Engine on page 18.
2. Pull both transaxle bypass levers out into
bypass position. See Figure 16.
3. Release parking brake and push unit to
desired location.
4. Engage parking brake.
5. Return transaxle bypass levers to
operating position. See Figure 17.
EN - 18
Figure 16
Figure 17