•
"1080 Upper case" on page 59
•
"1090 Audio board, audio board cable, power board, touch pad board cable, finger printer board,
LED board and ODD switch board" on page 61
•
"1100 System board" on page 64
• "1120 Speaker assembly, docking LED lens and docking bracket" on page 70
• "1130 LCD unit, docking board, docking cable and DC-in cable" on page 71
•
"1140 LCD front bezel" on page 74
Removal steps of the LCD panel, EDP cable and hinges
1
Remove four screws
Step
Screw (quantity)
1
M2.5 × 4mm, flat-headed, nylon-coated (4) (E41)
M2 × 3mm, flat-headed, nylon-coated (4) (E51)
Disconnect the EDP cable connector
When installing: Ensure that the connector is attached firmly.
Remove two screws
4
Step
Screw (quantity)
4
M2.5 × 4mm, flat-headed, nylon-coated (2)
and then remove the LCD panel
b
a
3
.
a
and the remove the hinges in the direction shown by arrow
2
.
a
a
a
b
b
Color
Black
Black
Color
Black
Chapter 10
Torque
3.0 +/- 0.3kgf-cm
1.85 +/- 0.15kgf-cm
5
.
Torque
3.0 +/- 0.3kgf-cm
.
Removing or replacing a FRU
75