Table of Contents
Advertisement
12 SERVICE WORK ON THE CHASSIS
12.9
66
K00546-10
Removing the lower triple clamp
V01785-10
V01757-10
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC‑F EU/BR)
Preparatory work
–
Press and hold the switch-off button
idling until the engine stops.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
(
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
Open the cable holder in front of the left radiator and detach
the wiring harness.
–
1
Loosen screw
.
–
2
Remove screw
.
–
Take off the upper triple clamp with the handlebar and set it
aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove O-ring
3
and protective ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
25 Nm (18.4 lbf ft)
Loctite
5
.
(
p. 109)
p. 123)
p. 124)
while the engine is
p. 122)
p. 62)
(
p. 108)
p. 64)
p. 74)
4
.
4
.
®
243™
Advertisement
Table of Contents
