Canon CP300 User Manual page 186

Problem
The cutting position is
off .
The printed area gets
cut.
The tube is cut at an
angle.
Cause/Things to Check
Are there any objects
around the media delivery
port that prevent the
media from being ejected?
Is there any load on the
tube transport?
Is the tube twisted or
warped?
Depending on your print
media and environment,
the print position may be
shifted or the length of one
tube (or one label) may be
diff erent from the setting.
182
Solution
Do not place any objects
around the media delivery
port. If there is an object
blocking the outlet, the
tube or label tape may not
be ejected straight and may
be cut in a bent shape.
Place the printer and the
print media on the same
table (or at the same
vertical position) so that
no load is applied to the
transport.
When using a tube reel,
lighten the load.
Correct any twists or warps
before loading. (P.23)
If the end of the tube is
bent due to winding or
other reasons, straighten
it out or cut off the bent
portion before loading it
into the printer.
Make fi ne adjustments to
the print position and cut
length.
(P.80)
If the problem is not
corrected by using the
length adjust, set the half
cut to "Off " and cut with
scissors.