Advertisement
DANGER!
• Your product is heavy. Remove packaging
reinforcement as displayed in the figure.
• Be careful not to get your hand caught
under the machine during this procedure.
3.3 Removing the transit bolts
A
PRECAUTION!
• Do not remove the transit bolts before
removing the packaging reinforcement.
• Remove the transit bolts before operating
the washing machine! Otherwise,
the product will get damaged.
C
INFORMATION
• Keep the transit bolts in a safe place
to reuse when the product needs
to be moved again in the future.
• Never move the product without the
transit bolts properly fixed in place!
12 / EN
1
1 Use a tool to
loosen all bolts until
they rotate freely.
2
2 Remove the transit
bolts by turning
them slightly.
3
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
3.4 Connecting water supply
C
INFORMATION
• It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in
one minute to have your product run
smoothly. Attach a pressure reducing
valve if water pressure is higher.
C
INFORMATION
• It is also recommended to attach a pressure
reducing valve if you experience overflow
from the detergent dispenser during water
fill between 3.5 to 10 bars (0.35 to 1 MPa).
A
CAUTION!
2
• Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
1
3
A
CAUTION!
• Ensure that the cold water connection
is made correctly when installing the
product. Otherwise, your laundry
will come out hot at the end of the
washing process and wear out.
1
3
2
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
2
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
Washer-Dryer / User's Manual
3
Advertisement
