Standby Mode - TESY AQUATHERMICA ECO 200 S User Manual

1
Turn ON
2s 2s
Standby
2
Turn ON
E-Heater
5s 5s
Enable/Disable
Fan Ventilation
1 When connecting the appliance to the main power supply, all icons
are displayed on the controller screen for 3 seconds. After that an initial
check is undergoing.If everything is ok, the unit enters into a standby mode
(fig.01)
Press and hold the button for 2 seconds when the unit is in standby. The
"Heating mode" will start. The display will look like (fig02)
To switch the unit OFF press

STANDBY MODE

While the heat pump is running, press this button
2
electrical heater will work according to the control program together with the compressor until theset temperature is reached.
When the heat pump is ON, press this button
tion is enabled the fan will continue working to ventilate the air, even when the water temperature reaches the set point and the unit
is in standby mode. On the contrary If this function is disabled the fan will stop, when the water temperature reaches the set point
and the unit is in standby mode.
3 During running status, press
The maximum achievable water temperature by heat pump only, depends on outside air inlet temperature and
could be seen on picture:
Press and buttons at the same time and hold for 5 seconds, the buttons are locked.
Press and buttons at the same time and hold for 5 seconds again, the buttons are unlocked
OPERATING MODES. USER INTERFACE
SET TEMP
WATER TEMP
C
ERRO R ON OFF
3
Set Temp
button and hold it for 2 seconds while the unit is running.
WATER TEMP
C
Fig. 01
and hold for 5 seconds to enable or disable the fan ventilation function. If this func-
or button to adjust the set temperature of water tank directly.
4
Adjust
Hour/Minute
C
5s 5s
Timer
5s 5s
Lock/Unlock
Buttons
5
5s 5s
HEATING MODE
SET TEMP
to turn 'ON' "Boost mode". The heater icon will be shown, and the
3
Set
Hour/Minute
Set
Hour
Save & Exit Cancel
Timer
Check Parameters
Check Parameters
WATER TEMP
C C
Fig. 02
Set
Minute
A-H
1-35