Table of Contents
Advertisement
A
B
KEY
A
Delta Spray Gun
See page 4 for gun part numbers.
B
Fluid Inlet; 3/8 npsm (R3/8–19)
C
Air Swivel Inlet; 1/4 npsm (R1/4–19)
D
Air Hose
Recommend 5/16" (7.9 mm) I.D. hose
E
Air Shut-off Valve
F
Air Regulator
G Air Filter
H
Air Supply Line
The Delta Spray air spray gun was designed to pro-
duce the highest quality finish with today's fluids as
well as the Low V.O.C. (volatile organic compound)
fluids of tomorrow.
This spray gun can spray all coatings or finishes
currently being used for automotive, industrial, aero-
space, marine, wood, plastic and architectural applica-
tions, while easily operating from any paint delivery
system, including cups, pressure pots, or remote
pumps for production line operation.
The air regulator must have a minimum air flow
capacity of 20 scfm at 100 psi (0.7 MPa, 7 bar) air
pressure. Refer to the Pressure Drop Charts, page
12.
8
308742
Typical Installation
C
E
F
D
Ventilate the Spray Booth
WARNING
To prevent hazardous concentrations of
toxic and/or flammable vapors, spray
only in a properly ventilated spray booth.
Do not operate the spray gun unless
ventilation fans are operating.
Check and follow all of the National,
State and Local codes regarding air ex-
haust velocity requirements.
Check and follow all local safety and fire codes.
H
G
07600A
Advertisement
Table of Contents
