Table of Contents
Advertisement
NLTroubleshooting
Malfunction
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
Loud noise during
spinning.
Clapping, clattering
in the pump.
Slurping, rhythmic
suction sound.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
50
Cause and Troubleshooting
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
The appliance is not leveled properly.
→ "Adjusting the device", Page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 16
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
A foreign object has entered the pump.
→
"Cleaning the drain pump", page 41
▶
Pump is active, the solution is being pumped out.
No error - normal operating noise.
▶
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Start the programCentrifuge.
▶
is activated.
Select a suitable program for the type of fabric.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Advertisement
Table of Contents
